MSK-TIM: A Telerobotic Ultrasound System for Assessing the Musculoskeletal System.

The aim of this paper is to investigate technological advancements made to a robotic tele-ultrasound system for musculoskeletal imaging, the MSK-TIM (Musculoskeletal Telerobotic Imaging Machine). The hardware was enhanced with a force feedback sensor and a new controller was introduced. Software improvements were developed which allowed the operator to access ultrasound functions such as focus, depth, gain, zoom, color, and power Doppler controls. The device was equipped with Wi-Fi network capability which allowed the master and slave stations to be positioned in different locations. A trial assessing the system to scan the wrist was conducted with twelve participants, for a total of twenty-four arms. Both the participants and radiologist reported their experience. The images obtained were determined to be of satisfactory quality for diagnosis. The system improvements resulted in a better user and patient experience for the radiologist and participants. Latency with the VPN configuration was similar to the WLAN in our experiments. This research explores several technologies in medical telerobotics and provides insight into how they should be used in future. This study provides evidence to support larger-scale trials of the MSK-TIM for musculoskeletal imaging.

Quantifying the Effects of Network Latency for a Teleoperated Robot.

The development of teleoperated devices is a growing area of study since it can improve cost effectiveness, safety, and healthcare accessibility. However, due to the large distances involved in using teleoperated devices, these systems suffer from communication degradation, such as latency or signal loss. Understanding degradation is important to develop and improve the effectiveness of future systems. The objective of this research is to identify how a teleoperated system's behavior is affected by latency and to investigate possible methods to mitigate its effects. In this research, the end-effector position error of a 4-degree-of-freedom (4-DOF) teleultrasound robot was measured and correlated with measured time delay. The tests were conducted on a Wireless Local Area Network (WLAN) and a Virtual Local Area Network (VLAN) to monitor noticeable changes in position error with different network configurations. In this study, it was verified that the communication channel between master and slave stations was a significant source of delay. In addition, position error had a strong positive correlation with delay time. The WLAN configuration achieved an average of 300 ms of delay and a maximum displacement error of 7.8 mm. The VLAN configuration showed a noticeable improvement with a 40% decrease in average delay time and a 70% decrease in maximum displacement error. The contribution of this work includes quantifying the effects of delay on end-effector position error and the relative performance between different network configurations.

A toolkit for haptic force feedback in a telerobotic ultrasound system.

OBJECTIVE: To develop a collision engine (haptic force feedback simulator) compatible with a 5-degrees-of-freedom (DOF) haptic wand. This has broad applications such as telerobotic ultrasound systems. Integrating force feedback into systems is critical to optimize remote scanning. A collision engine compatible with a 5-DOF haptic wand was developed based on the Gilbert-Johnson-Keerthi algorithm. The collision engine calculated force during collision between the wand and a virtual object based on code developed using MATLAB. A proportional force was subsequently returned to a user via the haptic wand, thereby simulating the collision force for the user. Three experiments were conducted to assess the accuracy of the collision engine on curved and flat surfaces. RESULTS: The average errors in calculation of distances between the wand and virtual object were 2.1 cm, 3.4 cm, and 4.2 cm for the model of the human hand, cylinder, and cuboid, respectively. The collision engine accurately simulated forces on a flat surface, though was less accurate on curved surfaces. Future work will incorporate haptic force feedback into a telerobotic ultrasound system. The haptic force simulator presented here may also be used in the development of ultrasound simulators for training and education.

Development and assessment of a telesonography system for musculoskeletal imaging.

BACKGROUND: Telesonography systems have been developed to overcome barriers to accessing diagnostic ultrasound for patients in rural and remote communities. However, most previous telesonography systems have been designed for performing only abdominal and obstetrical exams. In this paper, we describe the development and assessment of a musculoskeletal (MSK) telesonography system. METHODS: We developed a 4-degrees-of-freedom (DOF) robot to manipulate an ultrasound probe. The robot was remotely controlled by a radiologist operating a joystick at the master site. The telesonography system was used to scan participants' forearms, and all participants were conventionally scanned for comparison. Participants and radiologists were surveyed regarding their experience. Images from both scanning methods were independently assessed by an MSK radiologist. RESULTS: All ten ultrasound exams were successfully performed using our developed MSK telesonography system, with no significant delay in movement. The duration (mean ± standard deviation) of telerobotic and conventional exams was 4.6 ± 0.9 and 1.4 ± 0.5 min, respectively (p = 0.039). An MSK radiologist rated quality of real-time ultrasound images transmitted over an internet connection as "very good" for all telesonography exams, and participants rated communication with the radiologist as "very good" or "good" for all exams. Visualisation of anatomic structures was similar between telerobotic and conventional methods, with no statistically significant differences. CONCLUSIONS: The MSK telesonography system developed in this study is feasible for performing soft tissue ultrasound exams. The advancement of this system may allow MSK ultrasound exams to be performed over long distances, increasing access to ultrasound for patients in rural and remote communities.

A novel test to differentiate anosmic malingerers from actually anosmic patients.

BACKGROUND: The available olfactory evaluation tests are mainly subjective methods requiring patients' collaboration. If, for any reason, the patients refuse to honestly report what they perceive, the test reliability will be questionable; this condition is potentially observable in malingering patients because of their financial or psychosocial incentives. In an olfactory discrimination test context, this study was aimed to design a test capable of distinguishing malingerer from actually anosmic or severely hyposmic patients. METHODS: The pilot experiment of our methodology study determined five substances (coffee, lemon, rosewater, thyme, and garlic) as qualified odors of a 20-item odor discrimination test and set its normal reference value at 15. Through two simulations, 70 normosmic participants emulated actual anosmia and also malingering. The outcome results were used to measure test reliability factors. RESULTS: During the malingering simulation, only seven participants were capable of keeping their scores at the test chance level with enough randomness in their sequences of answers while the actual anosmia simulation revealed that 39 had scores at the test chance level. Accordingly, the Tehran University Odor Discrimination Test (TUODT) was measured to have 90% sensitivity, 55.71% specificity, 67.02% positive predictive value, and 84.78%negative predictive value. CONCLUSION: The TUODT is a relatively efficient method to identify anosmia malingerers.